|
Model: L0637
- Cybertech Trimod provides the highest level of spinal stabilization.
- Corset can be used alone or with the shell.
- Cybertech Trimod is perfect for recovery after spinal surgery.

The Cybertech TriMod Back Brace is a highly effective back brace that adjusts to your needs as your body heals surgery - simply by removing panels from the rigid frame. This Cybertech back brace combines incredible support, rigid stability and the ability to increase intercavitary pressure to relieve low back pain, all in one trimodular design. It has a removable unibody frame that wraps around the sides of the body like a shell, and can be removed from the back corset to allow justuse of the corset alone. The Cybertech TriMod has an orthopedic design to help control movement in all directions and provides a high degree of immobilization for the back. The Cybertech TriMod provides the highest level of spinal stabilizationt and is easy to put on and take off without difficulty.
Cybertech TriMod Features:
- FREE GROUND SHIPPING in the continental US on all orders over $100.
-
Rigid Unibody Frame provides superior posterior and lateral support.
-
Patented pulley system smoothly deliver 6 times more power to maximize compression.
-
1-hand, 1-second adjustability provides patient convenience to allow for standing or sitting. This puts the patient in control - which leads to greater compliance.
-
Single front fabric fastener makes it easy to don and doff.
-
Lightweight, impeccable construction with breathable side panels, insure greater comfort and compliance.
-
Interchangeable TriMod component sizes insure proper patient fit.
Sizing: Order based on waist measurement, from below. Note: If there is a substantial difference between chest measurement and waist measurement (ie: 8" - 10"), choose 1 size larger to help compensate for a larger chest. Small = 25-30" Medium = 30-35" Large = 35-40" XL = 40-45" XXL = 45-50" (additional $50.00) 3XL = 50-55" (additional $50.00) 4XL = 56-68" ONLY AVAILABLE IN 10" VERSION (additional $65) Versions: 8" or 10"
Fitting & User Instructions: Orthotist Instructions
-
Attach the brace to the TriMod Posterior Frame by sliding panel ends between attachment straps and center the brace.
-
Fit the system on the patient.
a. Position Anterior Panel
b. Pull tab to create compression on patient
c. Mark the anterior panel position relative to the inside left panel. Remove the orthosis from the patient.
-
Rivet the rigid anterior panel to the interior of left brace side panel using the supplied radiolucent medical rivets. Note: female rivet parts exactly fit the predrilled holes in the anterior panels. Male rivet parts follow a simple pilot hole made by any type of punch or awl in the 1/8? range. Alignment and compression of at least three rivets creates a stable attachment.
User Instructions:
-
Fasten the adjustment handle close to the pulley unit. The handle is always on the left.
-
Stand and hold the brace by its side panels, parallel to the floor.
-
Wrap the brace around the body; determine the best and most supportive vertical position.
-
Pull slightly outward on side panels to maximize open position before using fabric fastener to close the front - right over left.
-
Pull handle away from fabric and across the body, place it anywhere on fabric fastener strip to achieve desired support.
Treating Lordosis: Lordotic pads are included for placement per indicated need. For Maximum Effectiveness:
-
Before putting on the TriMod system, make sure the side panels are extended or pulled as far apart as possible.
-
The handle should always be on the left.
-
Always start with the handle near the pulley system.
-
The TriMod frame must be centered on the spine.
-
Experiment with adjustments by releasing or pulling the handle as you change position.
Recommended Manufacturer HCPC: L0637

|